As described in our Privacy Policy, we collect personal information from your interactions with us and our website, including through cookies and similar technologies. We may also share this personal information with third parties, including advertising partners. We do this in order to show you ads on other websites that are more relevant to your interests and for other reasons outlined in our privacy policy.
Sharing of personal information for targeted advertising based on your interaction on different websites may be considered "sales", "sharing", or "targeted advertising" under certain U.S. state privacy laws. Depending on where you live, you may have the right to opt out of these activities. If you would like to exercise this opt-out right, please follow the instructions below.
If you visit our website with the Global Privacy Control opt-out preference signal enabled, depending on where you are, we will treat this as a request to opt-out of activity that may be considered a “sale” or “sharing” of personal information or other uses that may be considered targeted advertising for the device and browser you used to visit our website.
Install Guide
*TAG Precision recommends our sights be installed by a
qualified gunsmith, while using a quality sight installation tool.
SIG INSTALL INSTRUCTIONS:
• Use your punch/drift on the dovetail (lowest surface of sight), and not on the body/blade of the sight. Pushing from the body/blade will cause the sight to tilt on an angle resulting in faulty install or breakage.
FRONT SIGHTS
• Make sure muzzle is always pointed in a safe direction
• Remove magazine and visually check the chamber to make sure the firearm is completely unloaded first and foremost
• For glock style front sights you will need to field strip the pistol to remove the recoil spring and the barrel from the slide
• Use the glock tool to remove the mounting screw on the front of the sight
• Degrease the contact surface of the sights and slide using rubbing alcohol
• Check the sights alignment and make any needed adjustments to center it on the slide.
• Install TAG Precision front sight on the top of the slide with the serrated end pointing towards the rear of the gun
• Test to make sure the sight fits flush, some fitting may be needed
• Do not overtighten the screw, only moderate force is needed to keep the sight in place
• Dovetail sights for the front and rears may require minor fitting due to the tolerances of gun manufacturers. Tag Precision recommend using a qualified gunsmith for these installations
REAR SIGHTS
• Use a c clamp to clamp the slide sideways on a flat, strong and non-moveable surface
• Use a hammer and nylon punch to remove the factory sight
• Degrease the dovetail slot on the rear slide
• Take the TAG Precision rear sight and insert it into the dovetail slot using finger pressure only. If it does not slide 1/3 of the way in the slot, then remove the sight and lightly file the bottom of the sight rotating 180 degrees every 3-5 times until the sight can be finger pressed 1/3 to ½ on the slot
• Check the alignment of the sights frequently and make any adjustments needed to center
This site requires cookies in order to provide all of its functionality.